TECHNICAL DATA 


          
GRIP FORCE ADAPTERS were engineered to be as thin as possible, yet
              still maintain their structural integrity where the bottom of the grip tang
              area meets the top of the back strap.  This was done to ensure that the
              least amount of material was added to this area so the GRIP ADAPTER
              would fit the widest variety of shooters of all hand sizes.  
 

              
              
              TRIGGER REACH (A):

              When adding a GEN 123 ADAPTER, the trigger reach dimensions are
              increased by: 

                                     .077" (seventy-seven thousandths of an inch or 1.96 mm) 
        
             
              When adding a GEN 4 ADAPTER to a GLOCK GEN 4 SF frame, the 
              trigger reach dimensions are increased by: 
             
                                     .091" (ninety-one thousandths of an inch or 2.31 mm)             
         

  
              
              BORE HEIGHT (B): 


              When adding a GEN 123 ADAPTER, the thickness of the underside
              of the grip tang area (Bore Height) is increased by: 
               
                                     .084" (eighty four thousandths of an inch or 2.13 mm)


              When adding a GEN 4 ADAPTER, the thickness of the underside of
              the grip tang area (Bore Height) is increased by: 
          

                                     .085" (eighty five thousandths of an inch or 2.16 mm)




          
      


 

 

Website Builder